11 • Next Sensor Session | Stelo Glucose Biosensor User Guide 65
Remove while using sensor
To remove old sensors from the Bluetooth connections list while you're wearing a
sensor, follow the above steps and keep these tips in mind:
l
All Stelo sensors are listed as not connected, even the current one. The current
sensor's status changes to connected during the few seconds every 5 minutes
when it's sending your sensor reading to your smartphone. If you watch the list for
up to 5 minutes, you'll see which sensor is the current one.
l
Don't worry if you remove the current sensor. Within 15 minutes, the sensor will
send your next sensor reading to your smartphone and the sensor will reappear in
the Bluetooth connections list. (If you use an iPhone, it will prompt you to re-pair
the sensor — no pairing code needed. Android phones do this automatically).
To Next Page
Loading...
