DIMAX804KC User’s Manual
DEXON Systems
7
Remote Control
This menu item contains the parameters of remote control:
• DHCP enable
• Specify IP address
• Set network mask
You should press the SET button to save the settings.
OSD
There is a built-in information text about the current output settings and input connections. This
information text can be visualized on the OSD (On Screen Display) panel. The visibility settings
of the OSD panel can be changed here.
• Auto: the information panel is automatically displayed in case of any changes in the
settings.
• Yes: the information panel is visualized permanently.
• No: the information panel is not visible.
By default, the information panel can be seen on the top-left corner of each display output. The
display time in case of Auto mode is 4 seconds. These parameters can be changed from the
controlling application.
Serial Port
The adjustable parameters are: Baud Rate, Databits, Parity, Stopbits and Flow Control.
Factory Reset
The factory reset is a full restore of device to its factory settings.
3.1.2
Layouts
Layout is a set of parameters describing arrangement of the input signals on the DIMAX device.
The layout determines:
• Input video and audio signals
• Outputs assigned to that inputs
• Input and output cropping values
• Picture-in-picture signals and positions
The Layouts menu contains the list of available layouts. There are the very same three items
inside each layout submenu:
o Layouts
▪ Layout #1
• Store
• Recall
• Clear
▪ Layout #2
• Store
• Recall
• Clear
▪ ...
▪ Layout #32
• Store
To Next Page
Loading...