42
Part # 8533-090-001 7/21
Cycles Option:
This option allows the user to set temperature and cooldown information for the drying cycle. It also al-
lows the user to return the values to factory defaults.
1. “TEMP SETTINGS” allows the user to make adjustments, within a designated range, to the
cycling temperature for each of the “Low”, “Medium” and “High” customer choices.
2. In addition, on the “Low” setting, the user can reduce the cycling temperature below 110
degrees F. In this case, when the customer chooses the “Low” setting, the dryer
will not turn on the gas valve. When checked, the displayed temperature will read
“NO HEAT”.
3. “COOLDOWN” allows the user to change the designated time at the end of a cycle where the
gas valve relay is turned o. On “High” and “Medium” temperature settings, the
designated time cannot be reduced to less than 2 minutes.
4. “DEFAULT TEMP” allows the user to choose which general temperature setting, “High”, “Me
dium” or “Low”, the control will default to at the beginning of each cycle if the customer
does not make a choice.
5. “ANTI WRINKLE” is a feature that periodically rotates the dryers after a cycle is complete. If the
door was closed at the end of the cycle, and is left closed for 5 minutes, the enuncia
tor will sound and the display begins scrolling “ANTI WRINKLE”. 5 seconds later,
the dryer motor will turn on for 60 seconds and then turn o. The gas valves will not be
turned on. The “ANTI WRINKLE” message will continue throughout the time that
the motor is turned on. The user can choose to enable or disable this feature.
To reset all values in the Cycles option to factory default, press “Enter” when the “DEFAULT” prompt is
shown. Press “Enter” again when the “RESET” prompt is shown to conrm the action.
To Next Page
Loading...
Need help?
General
