Diamondview DV55RM5 - Operating the Display; Setting up the Display

To Next Page

To Previous Page

Operating the Display

Setting up the Display

Step 1: Plug in the power cable and turn on the AC power switch (without turning on the signal source

device(s)).

Step 2: Plug in the signal source cables.

Step 3: Press the power key on the display’s keypad or the power key on the remote control to turn on the

display.

Step 4: Turn on the power of the signal source device(s) to begin sending a signal to the display.

“I” is power on

“O” is power off