14.4. EDITING MACROS [ 10 4 ]
In this section, you can edit the sequence of keys you have
programmed in a given macro. To access this setting:
Press MENU for 2 seconds.
To move from one option to another, use F2 to move down
the menu and F1 to move up.
Select the 10 Macros option, press
∗
∗∗
∗
and, here, select option
4, Edit Macros.
Enter the number of the macro you wish to edit and press
∗
∗∗
∗
to display the sequence of strokes of the keys corresponding
to the macro.
If, at the end of the description of the key, an asterisk (*)
displays, this means that it is an extended key stroke.
There are two operating modes :
Macro sequence control:
This operating mode is for controlling the keystrokes
assigned to the corresponding macro. In this mode, the keys
have the following functions:
+
++
+
Move forward in a keystroke position.
−
−−
−
Mover backward in a keystroke position.
C Delete the current keystroke.
T/FT Insert in the current position.
* Save the changes in the macro.
Editing macro keystrokes:
In this operating mode, the scale memorises the keys that
are pressed in blinking position.
To change from control mode to edit mode and vice
versa, just keep the total
∗
∗∗
∗
key pressed.
To Next Page
Loading...
