16
5.6. Clearing of Accumulated Data :
1 From previous operations (See 4.4. & 4.5.)
2 Pressing the [∗∗
∗∗
] key, clears the accumulated total.
5.7. Clearing Unit Weight :
1 Remove weight.
2 Pressing the
[C] key, clears the unit weight.
5.8. Scale 1__
__
2 Operation :
To change between Scale 1 (Built-in) and Scale 2 (Remote), please make sure that bit 1 of Spec 25 in
Weight and Measures specification is set to 1. Switch off the scale and turn it on again after setting
this spec. Or else you might notice a shift in the zero point, when changing between scales. The scale
change operation cannot be performed if there is any [Numeric] Key entry.
Display in the weighing mode
Pressing [SCALE] key changes from Scale 1 to Scale 2.
Pressing the [SCALE] key again changes back to Scale 1
Note :- The unit weight computed on Scale 1 can be transferred to Scale 2 and vice versa.
To Next Page
Loading...
