Digi TransPort WR21 - Page 383

Configuring network interfaces Configure PPP and external modems
Digi TransPort® Routers User Guide
383
Command Instance Parameter Values Equivalent web parameter
ppp n pingis off, on Only send Pings when this
interface is “In Service”
ppp n ping2cont off, on New connections to resume
with previous Ping interval
ppp n pingdeact 0-
2147483648
Reset the link if no response
is received within s seconds
ppp n pingfreth0 off, on Use ETH 0 IP address as the
source IP address
ppp n pingresetint off, on Defer sending pings if IP
traffic is being received
ppp n None - See dlwarnkb,
dlstopkb, dlrstday
parameters.
off, on Limit the data transmitted
over this interface
ppp n dlwarnkb 0-
2147483647
Issue a warning event after
n XBytes
ppp n dlstopkb 0-
2147483647
Stop Data from being
transmitted after n XBytes
ppp n dlrstday 0-255 Reset the data limit on the n
day of the month
ppp n When the link disconnects,
indicate that the connection
failed if no IP packets were
received
ppp n sscnt 0-
2147483648
Reset this interface if n
packets are transmitted and
the connection has been up
for at least s seconds
ppp n sssecs 0-
2147483648
Reset this interface if n
packets are transmitted and
the connection has been up
for at least s seconds
ppp n lscnt 0-
2147483648
Reboot the router after n
consecutive resets
ppp n rebootfails 0-
2147483648
Reboot the router after n
consecutive connection
failures
ppp n radius off, on Use RADIUS for
authentication when acting
as a server