Digi TransPort WR21 - Page 596

Configuring legacy protocols Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort® Routers User Guide
596
would not send this message, but instead wait for it to be sent to us before progressing in the
DLSw state machine.
Make immediate connection attempts before backing off
The number of successive connection attempts before backing off for the number of seconds
(default 30) defined in the Backoff for x seconds... parameter. This backoff might be
necessary when a server is behind a firewalls that detects too many successive connection
attempts in a certain time frame.
Backoff for x seconds before attempting to connect again
When backing off because of too many failed consecutive connection attempts, this parameter
defines the time, in seconds, the router should remain idle before attempting another
connection.
5. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
snaip x l1iface ISDN, Port,
SharedPort
Send SNAIP traffic over interface.
snaip x l1nb 0–255 (Select LAPB,
Port or SharePort
instance)
Send SNAIP traffic over interface.
snaip x protocol LAPB, SNA, RAW,
RAW_NOHDR
Use the specified protocol.
snaip x ans 1=enabled,
0=disabled
Allow this unit to answer calls.
snaip x msn text Only accept calls with MSN ending
with the specified text.
snaip x sub text Only accept calls with sub-address
ending with the specified text.
snaip x autocontact 1=enabled,
0=disabled
Assume station exists. (Do not send
TEST frames).
snaip x dcd_toggle 1=enabled,
0=disabled
Toggle DCD output each time the
DLSw protocol enters the
DISCONNECTED state.
snaip x l1oos 1=enabled,
0=disabled
Sync port should not send or receive
data when WAN link is down.
snaip x master 1=enabled,
0=disabled
Router to be Master on an
unbalanced link.
snaip x pollresp 0-2147483647 Polling Response Time.