Digi TransPort WR21 - Page 597

Configuring legacy protocols Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort® Routers User Guide
597
Command Instance Parameter Values Equivalent web parameter
snaip x stations text Polling Stations Addresses.
snaip x saps text SAPs.
snaip x dsaps text DSAPs(blank=default).
snaip x send_xid_null 1=enabled,
0=disabled
Send Null XID (XID with no Data).
snaip x xid_data text Send XID with Data.
snaip x turntxtim 0-2147483647 Tx Turn Around Time.
snaip x dtemode 1=DTE, 0=DCD Mode.
snaip x n400 0-255 N400 counter.
snaip x tnoact 1000-60000 RR Timer.
snaip x t1time 1-60000 T1 timer.
snaip x t200 1-60000 T200 timer.
snaip x window 1-7 Window Size.
snaip x tinact 0-3000 Disconnect link if there has been no
activity forxseconds.
snaip x vmac Text (valid MAC
address)
Virtual MAC Address.
snaip x peervmac Text (valid MAC
address)
Virtual MAC Address of Peer.
snaip x IPaddr Text (valid IP
address)
IP address of the Peer DLSw unit.
snaip x r_IPport 0-65535 Listen on Port.
snaip x w_IPport 0-65535 Use Port x if this unit starts the
DLSw protocol.
snaip X srcipent auto, eth, ppp Use interface for source IP address.
snaip x srcipadd 0-255 Use interface for source IP address.
snaip x sock_inact 0-2147483647 Close TCP connection if it is idle for
xsecs.
snaip x ver 0-2 DLSw Ver.
snaip x passive 0= active
1=passive
DLSw Role.
snaip x dlswwindow 1-100 DLSw Window.
snaip x udp_cap 1=enabled
0=disabled
UDP Capable.