Digi TransPort WR44 - Supported Command Types

Using the command-line interface Supported command types
Digi TransPort® Routers User Guide
120
Supported command types
There are several types of text commands:
n Application commands, also known as text commands: Application commands are specific
to Digi International products and control most features of the router when the Web interface
is not being used. For more information about application commands, see Application
commands.
n AT commands and S registers: Digi TransPort supports AT commands and Special registers (S
registers) to maintain compatibility with modems, when using the router as a modem
replacement. For more information about the AT commands, see AT commands.
n X.3 commands: These are standard X.3 commands for X.25 PAD mode only. See Configure X.25
parameters.
n TPAD commands: These are for TPAD mode only. See Configure TPAD parameters.