Digi TransPort WR44 - Configure Event Logcodes

Configuring alarms Edit event descriptions
Digi TransPort® Routers User Guide
699
Configure event logcodes
ÉWeb
1. Go to Configuration > Alarms > Event Logcodes.
The Event Logcodes configuration page controls the configuration of the event that is
displayed in bold font at the top of the page, just below the title bar.
2. Click on a particular link in the Event Logcodes page’s Event Description column; for example,
Power-up[%c]. The settings for the event are displayed.
3. Enter the event logcode settings as needed:
Do not log this event
When enabled, this setting disables logging of the event. This parameter is not saved in the
logcodes.txt file but in the config.dan file. This means that after changing this parameter, you
must save the changes by clicking the save changes link when prompted (this appears after
clicking the Apply button). If you click the Save All Event Code Changes, your changes are
not reflected.
Log Priority
The priority of the event to determine whether the event will trigger emails, SMS messages or
SNMP traps. 0=disabled, 1=highest priority, 9=lowest priority.