Using the command-line interface Application commands
Digi TransPort® Routers User Guide
145
reboot command: reboot router
The reboot command reboots the router after altering the configuration. The reboot command
executes a complete hardware reset, loading and running the main image from cold. It has three
modes of operation:
n reboot: Reboots the router after any FLASH write operations have been completed. The
following operations allow 1 second to be completed before a reboot occurs:
l IPSec SA delete notifications are created and sent
l TCP sockets are closed
l PPP interfaces are disconnected
n reboot <n>: A time reboot; reboots the router in <n> minutes where n is 1 to 65535.
n reboot cancel: Cancels a timed reboot if entered before the time period has passed.
To Next Page
Loading...
