Digi TransPort WR44 - Configure Advanced DSL Parameters

Configuring network interfaces Configure DSL interfaces
Digi TransPort® Routers User Guide
265
Configure advanced DSL parameters
ÉWeb
1. Go to Configuration > Network > Interfaces > DSL > Advanced.
2. Configure the advanced DSLparameters as needed:
Operational mode
The connection mode for the DSL link. The following options are available (default is Multi
mode).
Values Equivalent web parameter
Multi-mode For Annex A models (such as PSTN / POTS) this option provides automatic
selection between G.dmt, G.lite and ANSI (in the order listed).
For Annex B models (such as ISDN) this option provides automatic selection
between G.dmt (in the order listed)
ANSI Annex A only-attempt to connect in ANSI T1.413 mode
G.dmt Attempt to connect in ITU G.992.1 G.dmt mode
G.lite Annex A only-attempt to connect in ITU G.992.2 G.lite mode
ADSL2 Connect using ADSL2
ADSL2+ Connect using ADSL2+
Load DSL firmware from flash file ‘dspfw.bin’ (if present)
Enables use of alternative +ADSL driver firmware and should only be enabled on the advice of
the technical support team. This option also requires that an additional file be loaded onto the
router.
Enable watchdog
This setting should only be enabled on the advice of Digi Technical Support.
Manage this PVC using ATM OAM cells
Using Alarm indication signal (AIS) cells downstream and Remote defect indication (RDI) cells
upstream, the router can detect faults between the connecting points of the VP/VC and
suspend transfer of ATM cells until the VC fault condition is cleared.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
adsl 0 oper_mode Multi,ANSI,G.dmt,G.lite,ADSL2,
ADSL2+
Operational mode