Digi TransPort WR44 - Enable Command Filtering

Configuring security Use command filtering
Digi TransPort® Routers User Guide
811
2. In the Command field, enter the desired command to filter on into the text box and click Add.
3. Once a command is added, you can remove it from the command filtering table by clicking
Delete next to the command.
4. When you have entered all the commands on which you want to filter, clickApply .
Command line
Command Instance Parameter Values Equivalent web parameter
cfilter n cmd Valid command line command Command
cmd n cfilton 0, 1
0=Off
1=On
n/a
cmd n cfilterr 0, 1
0=Off-OK
1=On-ERROR
n/a
Enable command filtering
To enable command filtering from the command line for any particular instance of the command
interpreter, use the following command:
cmd <n> cf i l t on 1
The default action is to respond with the OK response. If the response needed is ERROR, use the
parameter:
cmd <n> cf i l t er r 1
Where n is the instance number.
Note Enclose any blank characters by double quotation marks. When substituting a command, upper
case characters are considered the same as the corresponding lowercase characters.