Digi TransPort WR44 - Page 190

Configuring network interfaces Configure Ethernet interfaces
Digi TransPort® Routers User Guide
190
Command Instance Parameter Values Equivalent web parameter
eth n group 0-3,255 Ethernet Hub group
eth n metric 1-16 Metric
eth n mtu 64-1500 MTU
eth n auton 0, 1 Enable auto-negotiation
eth n speed 0, 10, 100 Speed
0=Auto
10=10-BaseT
100=100-BaseT
eth n duplex 0, 1, 2 Duplex
0=Auto
1=Full
2=Half
eth n maxkbps value in kbps Max Rx rate
eth n maxtkbps value in kbps Max Tx rate
eth n tcptxbuf value in bytes TCP transmit buffer size
eth n linkdeact 0-86400 Take this interface out of service after n
seconds when the link is lost
eth n do_nat 0, 1, 2 Enable NAT on this interface
0=Disabled
1=IP address
2=IP address and Port
eth n ipsec 0, 1 Enable IPsec on this interface
eth n ipsecent blank, eth, ppp Use interface x,y for the source IP
address of IPsec packets
x=Interface type
eth n ipsecadd 0-255 Use interface x,y for the source IP
address of IPsec packets
y=interface number
eth n firewall 0, 1 Enable the firewall on this interface
eth n block_dns on, off Enable DNS inbound blocking
eth n dmnr_reg on, off Enable DMNR advertisement from this
subnet
eth n nocfg 0, 1, 2, 3 Remote management access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management and return RST