Digi TransPort WR44 - Page 452

Configuring IP routing and forwarding Configure Routing Information Protocol (RIP) settings
Digi TransPort® Routers User Guide
452
Include this interface in RIP advertisements
Select to cause the subnet configured on this interface to not be advertised by RIP.
Command line
Command Instance Parameter Values Equivalent web parameter
tun/ ppp n rip 0, 1 Enable RIP=1
Disable RIP=0
tun/ ppp n ripip Valid IP
address a.b.c.d
0=None
1=Access List
2=Plain Password
3=MD5 v2 only
tun/ ppp n ripauth 0-3 Key number
tun/ ppp n ripis on,off Turn on to send updates only when
in service
tun/ ppp n inrip on,off Include interface subnet in RIP
advertisements
tun/ ppp n triggeredrip on,off Enable RIP RFC2091