Digi TransPort WR44 - Page 461

Configuring IP routing and forwarding Configure multicast routes
Digi TransPort® Routers User Guide
461
this multicast packet. Otherwise, the router drops the packet, as the packet is likely to be a
copy, and the router has already received the original.
Add button
Adds the multicast route to the IP configuration.
3. Click Add to add each multicast route to the multicast routing table.
4. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
mcast 0-19 IPaddr Valid IP address a.b.c.d Multicast Address a.b.c.d
mcast 0-19 mask Valid IP address a.b.c.d Mask a.b.c.d
mcast 0-19 ll_ent PPP,ETH,TUN Interface x,y
mcast 0-19 ll_add Valid interface number 0-
2147483647
Interface x,y
mcast 0 mult_spc ON, OFF Enable multicast source path
checking