Digi TransPort WR44 - Page 807

Configuring security Use TACACS+ to control access to the router
Digi TransPort® Routers User Guide
807
Enable local authentication if there is no response from the server(s)
Allows local authentication if TACACS+ authentication fails.
Enable TACACS+ Authentication
Enables authentication. When authentication is enabled, user authentication takes place on
the TACACS+ server. When disabled, user authentication takes place locally on the router.
Enable TACACS+ Authorisation
Enables authorization which means that authorization of the application takes place and
authorization of application-related commands also takes place.
Enable TACACS+ Accounting
Enables accounting. Sends accounting messages at the start and end of application sessions,
where applicable, and update messages from command sessions when commands are denied
locally or after they are executed.
3. Click Apply.
Command line
Command Instance Parameter Values
Equivalent web
parameter
tacplus 0 svr Up to 64 characters
for hostname or valid
IP address a.b.c.d
Hostname or IP address
of server
tacplus 0 port 0-2147483647
Default 49
Port
tacplus 0 key Up to 20 characters Server Key
tacplus 0 svr2 Up to 64 characters
or valid IP address
a.b.c.d
Hostname or IP address
of server
tacplus 0 key2 Up to 20 characters Server Key
tacplus 0 localauth off, on Enable local
authentication if there is
no response from the
server(s)
tacplus 0 authent off, on Enable TACACS+
Authentication
tacplus 0 author off, on Enable TACACS+
Authorization
tacplus 0 acct off, on Enable TACACS+
Accounting