DigiDesign Command|8 User Manual

Command|8 Guide48
Switches In Stand-Alone mode, 32 of the Com-
mand|8 switches are available in both pages of
each preset.
The channel Mute and Solo switches are
premapped to CC 14 (mute) and CC 15 (solo);
Channel Select switches are not premapped.
The Channel View selectors (EQ, Dyn, Insert,
Pan/Send, < > Plug-in Page, Master Bypass, and
Esc) are dedicated (pre-programmed) to CC
121–127 as follows (they retain these assign-
ments even when switching pages or presets,
and can not be changed.
Transport Switches The Transport switches are
permanently mapped to standard MMC (MIDI
Machine Control) messages. (The RTZ switch
does not support MMC.)
The following controls are not programmable:
• Encoder mode selectors
•Display Mode
• Modifiers
• Master faders
• Flip
•Bank
•Nudge
•Arrows
•F1–F5
• Stand-Alone
• Control Room switches.
Editing MIDI Maps
This section provides instructions for program-
ming (mapping) Command|8 faders, encoders,
and switches.
To enter MIDI Edit mode:
1 Make sure Command|8 is in Stand-Alone
mode.
2 Press F3 PRE MIDI Recall and select a preset to
edit. (See “Selecting Presets” on page 51.)
Programmable switches in Stand-Alone mode
Channel View switch CC assignments
Switch CC assignment
EQ 121
Dynamics 122
Insert 123
Pan/Send 124
< Page 125
Page > 127
Master Bypass toggle Latch/Momen
Esc Name (edit)
Programmable
switch rows
Custom mapping can be saved as presets,
and presets can be created, named, and
saved before doing any mapping. See “Pre-
sets to Save and Recall Maps” on page 51.

DigiDesign Command|8 Specifications

General

Brand	DigiDesign
Model	Command|8
Category	Music Mixer
Language	English