D i g i g r a m
12
• Select the components to install. Select Wave if you want to install the
Wave driver in addition to the DirectSound driver. Click on Next.
• Under XP and Server 2003, select Continue anyway when the following
message is displayed:
”The software has not passed Windows Logo testing”.
If you have chosen to install the Wave driver, this message will appear a
second time. Select again Continue anyway.
• Click on Finish.
The DirectSound, ASIO, (and Wave if selected) drivers are now installed.
Removing the VX driver under Windows 2000, XP,
and Windows Server 2003
• Go to <Start> <Settings> <Control panel> <Add/Remove Programs>.
• Select the ‘Digigram VX Kit …’ and remove it.
• Follow the instructions of the InstallShield wizard.
Updating the VX driver under Windows 2000, XP, and
Windows Server 2003
• Remove the driver as described above.
• Run the installation program of the new driver, as described above.
Note: If you have done an installation without selecting the Wave driver,
and you now want to install it, it is necessary to remove the
(DirectSound) driver, and then re-install it.
To Next Page
Loading...
