D i g i g r a m
14
VX222
v2
SETTINGS UNDER MAC OS X
Several control panels are available to adjust the settings of the VX222v2. Some
parameters can be adjusted from different panels. If a parameter is modified in
a panel, its value is automatically updated in another panel.
VX Control panel
Use the VX Control panel to set the following parameters of your VX card:
• choice of VX card (if several VX cards are installed, they are noted as:
VX222:0, VX222:1, etc...)
• latency (Internal Buffer Latency): a low latency value may lead to
overloads in the audio causing clicks. If this happens, increase the
latency value
• sample size: 16 or 24 bits
• selection of the input source: digital, line, line with digital
synchronization
• hardware monitoring: can be activated or disabled by (un)checking
"Monitoring Input 1 2" (Monitoring Input 3 4 is inactive).
• digital input gain from -72 dB to +18 dB: the active cursor (Digital Input
1 2) allows simultaneous adjustment of the digital gain for both inputs.
To Next Page
Loading...
