Digigram VX222v2 - Specifications; Configuration Details; Inputs and Outputs

D i g i g r a m
26
SPECIFICATIONS
CONFIGURATION
Bus/Format PCI slave mode
Size
175 mm × 99 mm
Digital Signal Processor 56303 at 100 MHz
Power requirements
(+3.3 V / +5 V / +12 V / –12V) 0.5A / 0.1A / 0.2A / 0.1A
Operating: temp / humidity (non-
condensing)
0°C/+50°C • 5%/90%
Storage: temp/humidity
(non-condensing)
-5°C/+70°C • 0%/95%
INPUTS / OUTPUTS
Analog line inputs (mono)
2 balanced
∗
Maximum input/impedance
+22 dBu / >10kΩ (jumper ON)
+10 dBu / >10kΩ (jumper OFF)
Programmable input gain digital
Digital inputs (stereo)
1 AES/EBU
∗∗
Other inputs 2 GPI (dry contact)
Analog line outputs (mono)
2 servo-balanced
∗∗∗
Maximum output/impedance +22 dBu/low impedance
Programmable output gain digital and analog
Digital outputs (stereo)
1 AES/EBU
∗∗
Other outputs
headphone (600 Ω),
two GPO (relay, 0.5A, 48 VCC)
Access to main status bits
of digital frame
Yes
AES11 synchronization Yes
Connectors 15-pin SUB-D for analog I/O,
15-pin HD SUB-D for digital I/O,
and GPIO;
headphone jack (female TRS 3,5 mm)
∗
can be used with unbalanced signals
∗∗
can be used as S/PDIF interface as well
∗∗∗
electronically servo-balanced outputs provide automatic level adjustment to accommodate
either balanced or unbalanced lines