DG-HR3400 User Manual
47
this Access Point.
Enable Wireless
Isolation
If checked, the wireless client under this SSID can only access
internet and it can`t access other wireless clients even under the
same SSID, Ethernet clients or this device. Other clients can`t
access the wireless client, either.
Name(SSID)
Enter a value of up to 32 alphanumeric characters. The same
name (SSID) must be assigned to all wireless devices in your
network. The default SSID is "DIGISOL”, but we strongly
recommend that you change your network`s name (SSID) to a
different value. This value is case-sensitive. For example, SSID
is not the same as SsiD.
Mode Select the wireless mode you want to use. The options are:
802.11b mode. With a maximum speed of up to 11 Mbps.
802.11g mode. With a maximum speed of up to 54 Mbps.
802.11n mode. The band width is 20M, with a maximum
speed of up to 130 Mbps(short preamble, with a maximum
speed of up to 150 Mbps); The band width is 40M, with a
maximum speed of up to 270 Mbps(short preamble, with a
maximum speed of up to 300 Mbps).
802.11b/g mode. With a maximum speed of up to 54 Mbps.
802.11n/g mode. The band width is 20M, with a maximum
speed of up to 130 Mbps(short preamble, with a maximum
speed of up to 150 Mbps); The band width is 40M, with a
maximum speed of up to 270 Mbps(short preamble, with a
maximum speed of up to 300 Mbps).
802.11b/g/n mode. The band width is 20M, with a maximum
speed of up to 130 Mbps(short preamble, with a maximum
speed of up to 150 Mbps); The band width is 40M, with a
maximum speed of up to 270 Mbps(short preamble, with a
maximum speed of up to 300 Mbps).
Channel
This field determines which operating frequency will be used. It
should not be necessary to change the wireless channel unless
you notice interference problems with another nearby access
point.
To Next Page
Loading...
