DG-WA30002NP User Manual
If you select 2.4GHz (B+G), then only wireless clients
using 802.11b and 802.11g band will be able to connect to
this Access Point.
If you want to allow 802.11b, 802.11g, and 802.11n clients
to connect to this Access Point, select 2.4GHz (B+G+N).
MAIN ESSID Please input the ESSID (the name used to identify this
wireless Access Point) here. You can input up to 32
alphanumerical characters. PLEASE NOTE THAT
ESSID IS CASE SENSITIVE.
Channel Number Please select a channel number you wish to use. The
channel number must be same as the other wireless Access
Points you wish to connect.
Associated
Clients
Click ‘Show Active Clients’ button and a new popup
window will appear which contains the information about
all wireless clients connected to this Access Point. You can
click ‘Refresh’ button in popup window to keep
information up-to-date.
Root AP SSID In ‘Universal Repeater’ mode, this device can act as a
station to connect to a Root AP. You should assign the
SSID of the Root AP here or click ‘Select Site Survey’
button to choose a Root AP.
Select Site
Survey
Click ‘Select Site Survey’ button, then a “Wireless Site
Survey Table” will pop up. It will list all available Access
Points near by. You can select one Access Point in the table
and the Access Point will join wireless LAN through this
Access Point. Please go to Section
2-4-2-1 for more
information about the ‘Wireless Site Survey Table’.
53
To Next Page
Loading...
Need help?
General
