System OK LED Flashing
A-8
Message: Local—941—Transceiver loopback error
Problem: The Ethernet port has failed self-test.
Correction: Determine which of the following corrections applies to your
situation:
Check to ensure that the Ethernet selector switch is selecting the
appropriate connector.
Standard Ethernet/ThinWire – Replace the cables or MAU. Test again
by pulling out the power cord and reinserting. If this corrects the
problem, the fault is external to the DECserver. If this fails to correct
the problem, notify the network manager to return the DECserver to
Digital Network Products Group for repair or replacement. Refer to
the Network Access Software Problem Solving Guide for information
about returning the DECserver.
10BASE-T Ethernet – Replace the cables and device that is connected
to the DECserver. If this corrects the problem, the fault is external to
the DECserver. If this fails to correct the problem, notify the network
manager to return the DECserver to Digital Network Products Group
for repair or replacement. Refer to the Network Access Software
Problem Solving Guide for information about returning the
DECserver.
Message: Local—952—Enter ^P to repeat self-test
Problem: An error was detected on the Ethernet port.
Correction: The DECserver displays this message with message 941. Refer to
message 941 for the correction.
To Next Page
Loading...
