A-7
System OK LED Flashing
System OK LED Flashing
If the System OK LED is flashing after power up, it indicates that the DECserver has
a nonfatal problem detected during self-test. The error message on the console terminal
shows the primary problem.
To isolate and diagnose the problem, do the following:
Error Messages
This section lists and describes the error messages that occur with the System OK LED
flashing. The section also describes the recommended corrective action.
Step Action
1 Connect a console terminal to the console port (default port is port 1) of
the DECserver, then power up the terminal. Refer to the Network Access
Software Management Guide for procedure to set up the console port.
2 Configure the terminal to operate with a speed of 9600 bits per second
and a character size of 8 bits (no parity). (Refer to the specific terminal
user’s guide if you need help setting up the terminal parameters.)
3 Unplug the DECserver power cord at the wall outlet, then reinsert it.
4 Read the error message that appears on the terminal display.
Message: Local—922—Port hardware error on port n
Problem: The specified port has failed self-test.
Correction: There is no corrective procedure for this condition. Notify the network
manager that the DECserver must be returned to Digital Network
Products Group for repair or replacement. Refer to the Network
Access Software Problem Solving Guide for information about
returning the DECserver.
To Next Page
Loading...
