Digital Projection E-Vision Laser 6500 Series User Manual

Digital Projection
E-Vision Laser 6500 Series User Manual
Rev B August 2017
— 16 —
3.
If more than one input device is
connected, press the SOURCE button
and use ▲▼ to scroll among devices.
(Component is supported through the
RGB to Component adapter.)
 HDMI 1: High-Definition Multimedia Interface
compatible
 HDMI 2 / MHL: High-Definition Multimedia Interface
and Mobile High-Definition Link compatible
 DVI: DVI
 VGA 1: Analog RGB
DVD input YCbCr/ YPbPr, or HDTV input
YPbPr via D-sub connector
 BNC: Analog RGB
 Composite Video: Traditional composite video
 HDBaseT: Digital Video trough the HDBaseT
transmitter
Note:
Only available in Audio and Video received.
Using a single HDBaseT CAT5e cable, the projector
supports an HDBaseT connection distances to
100m/328ft.
4.
When the “Power Off? /Press Power
again” message appears, press the
POWER button. The projector turns off.
Caution:
Do not unplug the power cord until the POWER LED stops flashing – indicating the projector has
cooled down.

Digital Projection E-Vision Laser 6500 Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 6500 Series
Category	Projector
Language	English