Digital Projection E-Vision Laser 6500 Series - Settings 2 Menu

Digital Projection
E-Vision Laser 6500 Series User Manual
Rev B August 2017
— 40 —
Settings 2 Menu
Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the Settings 2
menu. Press the cursor ▲▼ button to move up and down in the Settings 2 menu.
ITEM
DESCRIPTION
Auto Source
Press the cursor ◄► button to enter and enable or disable automatic source
detection.
No Signal Power
Off (min.)
Press the cursor ◄► button to enter and set automatic shutdown of Light source
when no signal.
Auto Power On
Press the cursor ◄► button to enter and enable or disable automatic power On when
AC power is supplied.
Light Mode
Press the cursor ◄► button to enter and select the Light mode for higher brightness
or lower brightness to save light source life.
Reset All
Press (Enter) / ► to reset all settings to default values.
Status
Press (Enter) / ► to enter the Status menu. See page 41 for more information on
Status.
Advanced 1
Press (Enter) / ► to enter the Advanced 1 menu. See Advanced 1 Feature on
page 42.
Advanced 2
Press (Enter) / ► to enter the Advanced 2 menu. See Advanced 2 Feature on
page 54.
Custom Light
In Custom Light mode press the cursor ◄► button to enter and adjust the brightness
of the projectors to similarity.
Note: When Light Mode set to Custom Light, Custom Light function Enable.
Note :
Extreme Dimming: Saving 50% light source power consumption by blank screen (press BLANK button)