21
Stream Mode: Choose the recording resolution. The available options are Mainstream and
Substream.
PreRecord: If this option is enabled, the DVR starts recording a few seconds before an event
occurs. Use this option if your primary recording type is motion based.
Record Schedule
5.3.2
This menu allows you to specify when the DVR records video and define the recording mode for
each channel. The recording schedule lets you set up a schedule like, daily and hourly by normal
(continuous) recording, motion recording, and alarm recording. To set the recording mode, click
first on the mode radio button (Normal, Motion, or Alarm), then drag the cursor to mark the slots.
The recording schedule is valid only for one channel. If you want to use the same recording
schedule for other channels, use Copy To function.
Channel: Select the channel to set its recording parameters.
Normal: When the time slot is marked green, this indicates the channel performs normal recording
for that time slot.
Motion: When the time slot is marked yellow, this indicates the channel records only when a
motion is detected during that time slot.
NOTE: To use the motion detection, you must enable and configure the motion settings for the
channel in Alarm menu. Please see 5.6.1 Motion
Alarm: When the time slot is marked red, this indicates the channel records only when the sensor
is triggered during that time slot.
No Record: A time slot marked black means that there is no recording scheduled for the time slot.
To Next Page
Loading...