62
Remote Access via Web Client
Chapter 6
Use the Web Client to remotely access your DVR at any time via a PC. Before you access the
Web Client, you need to ensure that the network settings of the DVR are configured properly. The
most convenient and easiest way is if you have set the DVR a static IP address (please see
“5.5.1 Network”). It means you only need to open the web browser on your PC and type in the
static IP address you have set on the DVR. However, if the IP address of the DVR is assigned by a
DHCP server (see “5.5.1 Network”), then it means that each time you reboot the DVR, the IP
address changes. In this case, ask if your ISP can provide you a static IP address. If not, then
configure the DDNS service. See the network settings in “5.5.4 DDNS”.
System Environment Requirements
The minimum requirements for hardware and OS required to run Web Client are given as below.
Item Minimum Recommended
CPU Intel i3 Intel i7 or higher
RAM 4G or more 8G or more
Hard Drive 500G or more 1000G or more
Display RAM 2G or more 4G or more
Display Resolution 1280*1024 1920*1080
OS Windows® Vista, Windows® 7, Windows® 8 Mac OS X® 10.9 and above
DirectX DirectX 11
Direct3D Acceleration Function
Ethernet Adapter 10/100M Ethernet Adapter
IE Microsoft Internet Explorer (Ver. 11, 10, 9, 8)
Mozilla Firefox 43.0.4 or above
Google Chrome V44 or below
Mac Safari 5.1 or above
Web Plugin Download and Installation
6.1
To access the Web Client, do the following:
For IE/Chrome/Firefox:
1) Launch the explorer on your PC and enter the DVR static IP address or DDNS domain name
(Host Name) you have set on DVR in the URL box.
To Next Page
Loading...