4 www.dimplex.com
→ Activated and adjusted by repeatedly pressing the cor-
responding button on the remote.
• Indicated by the heater running at full heat, for a user set
amount of time, to quickly heat up a cold room/space.
The Heat Boost can be set for a maximum of 20 minutes,
in 5 minute increments.
Disable Heat
If desired, depending on the season, the heater on the unit
can be disabled. The function of the remaining controls will
continue to function as outlined in this manual.
Pressing the
and buttons on the unit at the same
time and holding for 2 seconds will disable and enable the
heater.
!
NOTE: When the heater has been disabled and any of
the heat related functions are used, the Display will indicate
“---”.
H.
Color Themes
Dierent presets of lighting color combinations are avail-
able in the unit.
→ Changed by repeatedly pressing the corresponding but-
ton on the remote or the unit.
• Cycles through the dierent preset light settings of the
unit, this includes dierent combinations of colors of the
ame base and media lighting.
!
NOTE: Two of the themes in the cycle are a prism
where the unit cycles through a variety of colors. Pressing
the
stops the cycling and holds the unit on the preferred
color, indicated by a solid circle. When the unit is on prism,
and is cycling through the colors, a rotating circle will be
displayed.
I.
Brightness
Changes the Brightness of the lights in the unit.
→ Adjusted by repeatedly pressing the corresponding but-
ton on the remote or the unit.
• Indicated by the second digit on the Display changing to
show: “H” (high), and “L” (low).
J.
Sleep Timer
The Sleep Timer can be set to automatically shut o the
replace after a preset time (from 30 minutes to 8 hours).
→ To set the timer press the timer button on the remote,
repeatedly, until the desired time is displayed.
• The Display will display the dierent times as it is ad-
justed. Once the timer has begun, pressing the
button
will display the time remaining before the unit turns O.
!
NOTE: The Sleep Timer can be cancelled at any time
by pressing the
button repeatedly until the sleep timer
displays nothing.
Resetting the Temperature Cuto Switch
Should the heater overheat, an automatic cut out will turn
the whole unit o and it will not come back on without being
reset. If the
button on the unit is pressed, Er2 will be
Figure 2
A
D
B
C
E
G
J
F
H
I
displayed on the unit. It can be reset by turning the unit o
at the main disconnect panel and waiting 5 minutes before
turning the unit back on.
CAUTION: If you need to continuously reset the heater,
turn the unit o at the main disconnect panel and call tech-
nical support at 1-888-346-7539.
Remote Control Battery Replacement
To replace the Battery:
1. Slide battery cover open on the remote control.
2. Correctly install one 3 Volt (CR2032 [longer life] or
CR2025) Battery in the battery holder.
3. Close the battery cover.
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for recyc-
ling advice in your area
Additional key Combinations
Software Revision Display - On the unit, hold
and
to display the software revision of the unit.
Factory Reset - On the unit, hold the
and the
, until
the display shows “ooo”
To Next Page
Loading...
Need help?
General
