5
Optimized layout for A4 print.
TECH_MAN_ENG_LTP
• The weighing system does not change the safety regulations normally applied to the forklift.
• Before weighing, make sure that the forklift is stationary, on a flat surface and that there are no people in the area around the load.
• The employee training on the use of the system is the purchaser’s responsibility.
• Please read this manual carefully before using the system.
• Assistance must only be carried out by personnel authorised by Dini Argeo.
• Dini Argeo is not responsible for any weighing errors resulting from improper use of the system.
For proper operation of the system, the forklift must meet the following requirements:
• Minimum friction between the sliding parts.
• No oil leaks.
• Good lubrication of the mast and chains.
• Good level of cleanliness.
• Use of an oil with a high viscosity index.
To make the system repeatable (i.e. to display the same weight when weighing in succession), the forklift must be kept in constant condition,
therefore regular cleaning and maintenance must be carried out.
Warnings
Forklift requirements
To Next Page
Loading...
Need help?
General
