Before you start
DTR250SS10 7
IMPORTANT SAFETY INSTRUCTIONS -
READ CAREFULLY BEFORE USE
Keep these instructions
1. Do not use this box near water
2. Clean only with a slightly damp cloth
3. Do not block any ventilation openings
4. Install in accordance with the supplied Quick
Start Guide and this User Guide
5. Do not install or operate near any heat
sources such as radiators, stoves, or other
apparatus that produce heat
6. Protect the power cord from being walked on
or pinched, particularly at plugs, and the point
where it exits from the box
7. Do not allow the power cord to overhang the
edge of a table
8. Unplug this box from the mains and aerial
during lightning storms or when unused for
long periods of time
9. To avoid interference, switch this box off while
operating other radio devices in the
immediate vicinity
10. Refer all servicing to qualified service
personnel. Servicing is required when the box
has been damaged in any way, such as the
power cord or plug being damaged, liquid
being spilled on or objects have fallen onto
the box, the box has been exposed to rain or
moisture, does not operate normally, or has
been dropped
11. No naked flame sources such as candles
should be placed on the box
WARNING: TO REDUCE THE RISK OF
FIRE OR ELECTRICAL SHOCK, DO NOT
EXPOSE THIS BOX TO WATER OR
MOISTURE. THE BOX MUST NOT BE
EXPOSED TO DRIPPING AND
SPLASHING AND NO OBJECTS FILLED
WITH LIQUIDS SHOULD BE PLACED ON
THE BOX
WARNING: RISK OF ELECTRIC
SHOCK. THIS BOX CONTAINS NO
USER SERVICEABLE PARTS. DO
NOT REMOVE ANY COVERS
Important
This box generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with these instructions, may cause
harmful interference to radio communication.
However, this is no guarantee that interference will
not occur in a particular installation. If the unit does
cause harmful interference to electrical devices,
which can be determined by turning the box off and
on, the user is encouraged to try to correct the
interference by one of the following measures:
1. Re-orient or relocate the receiving aerial
2. Increase the separation between the external
device and the box
3. Connect the external device into an outlet on
a circuit different from that to which the box is
connected
4. Consult the dealer or an experienced radio/TV
technician for help
To Next Page
Loading...