28
© 2008 Directed Electronics All rights reserved.
To adjust the Impact sensor:
Press 1.
to increase sensitivity to the next setting. The LED flashes
2 times after each button press to confirm the adjustment change.
Press 2.
to decrease sensitivity to the next setting. The LED flashes
1-time for each button press to confirm the adjustment change.
You can test the adjustment setting by striking the vehicle with the 3.
amount of force you want for the system to trigger. The horn honks
to confirm that the alarm triggers at that setting.
There is no adjustment for the Warn Away setting.
Shock sensor programming exits when:
The ignition is turned ON•
The Valet/Program button is pressed too many times.•
More than 15 seconds elapses between steps.•
The horn/siren emits 1 short and 1 long honk, and the LED flashes 0
to 16 times, depending on the programmed setting, and then shuts off
to confirm the shock adjustment mode is exited.
To Next Page
Loading...
Need help?
General
