42
© 2008 Directed Electronics All rights reserved.
Master dealer remotes
To program the Master Dealer Remote to the Security System:
Open a door.1.
Turn the key to the On position.2.
Within 5 seconds, press and release the integrated LED/Valet switch 3.
the number of times as described in the Transmitter Programming
Grid shown below, and then Press the switch one time and HOLD it
The LED flashes and the horn honks (if connected) to confirm the
selected step. Do not release the integrated LED/Valet switch.
While holding the integrated LED/Valet switch, press the
button on the transmitter you are programming.The vehicle’s horn
honks to indicate successful programming.
Note: It is not possible to teach a transmitter button to the system
more than one time. Up to 4 transmitters can be learned to your
Security System.
Release. Once the transmitter is learned, the integrated LED/Valet 4.
switch can be released.
Transmitter programming table
Step No. Function Wire Color
1 Auto learn standard configuration NA
2-7 No function for dealer master remote NA
8 Delete all transmitters N/A
To Next Page
Loading...
Need help?
General
