43
© 2008 Directed Electronics All rights reserved.
When installing the system, it is possible to preset all of the operation
settings using the master dealer remote. However, when the system is
operated using the master dealer remote, a special set of dealer default
settings are followed.
The dealer default settings are used to ensure that every vehicle
equipped with this system is protected at all times. All system features
can be programmed to meet the installation needs but only the settings
listed below are affected in master dealer mode.
Passive arming•
Confirmation honks off•
Ignition lock and unlock on (if installed)•
Passive locking (if programmed on)•
Ignition domelight on•
Security features off•
Valet mode disabled•
The above listed features are set and remain so until the Master Dealer
mode is exited. When the vehicle is ready to be delivered to the end
user, the Master Delear Remote must be deleted and the orginal re-
motes programmed back to the security system. The system then op-
erates according to how the operating settings have been preset. It
is also possible to reprogram the operating settings by following the
feature programming section of this guide.
To Next Page
Loading...
Need help?
General
