7
© 2008 Directed Electronics All rights reserved.
➤ Before beginning the installation
Check with the customer to determine the integrated LED/Valet •
switch location
Remove the domelight fuse or turn off the courtesy lights to prevent •
the battery from dying
Roll down a window to avoid being locked out of the car•
➤ After the installation
Test all functions. The Using Your System section of the Owner’s •
Guide is very helpful when testing.
When testing, remember this system is equipped with Nuisance •
Prevention® Circuitry. NPC™ can bypass both instant trigger
zones and make them seem to have stop working.
Carefully reassemble the underdash trim panels. •
Inspect the engine compartment for tools that may have been left •
behind.
To Next Page
Loading...
