10
© 2008 Directed Electronics. All rights reserved.
¢Before beginning the installation
Please read this entire installation guide before beginning the installation. s
The installation of this remote start system requires interfacing with many of
the vehicle’s systems. Many new vehicles use low-voltage or multiplexed
systems that can be damaged by low resistance testing devices, such as
test lights and logic probes (computer safe test lights). Test all circuits with a
high quality digital multi-meter before making connections.
Do not disconnect the battery if the vehicle has an anti-theft-coded radio. s
If equipped with an air bag, avoid disconnecting the battery if possible.
Many airbag systems will display a diagnostic code through their warning
lights after they lose power. Disconnecting the battery requires this code to
be erased, which can require a trip to the dealer.
If using an external LED or Valet Switch, check with the customer about s
where to locate the switch.
To avoid accidental battery drainage; turn off the interior lights or remove s
the dome light fuse.
Roll down a window to avoid being locked out of the car.s
¢After the installation
Test all functions. The Using Your System section of the Owner’s Guide is s
very helpful when testing.
Review and complete the Safety Check section of this guide prior to the s
vehicle reassembly.
To Next Page
Loading...
Need help?
General
