42
© 2008 Directed Electronics. All rights reserved.
System features learn routine
The System Features Learn Routine dictates how the unit operates. It is possible to
access and change any of the feature settings using the Valet/program switch.
However, this process can be simplified by using the Bitwriter®. Any of the
settings can be changed and then assigned to one of four remote controls. This
feature is called Owner Recognition. Each time that particular remote control is
used to disarm the system, the assigned feature settings will be recalled. Owner
Recognition is only possible when programming the unit via the Bitwriter®.
If programming with the Bitwriter®, the learn routine can be locked or
unlocked. If the learn routine has previously been locked, it must be
unlocked with Bitwriter® - this cannot be done manually with the Valet
switch.
1. Ignition. Turn the ignition on, then off.
(The heavy gauge PINK wire must be connected.)
2. Select a Menu. Press and HOLD the Valet/Pro-
gram switch. (The Valet/Program switch must be
plugged into the blue port.) After three seconds the
LED flashes and the horn honks one-time, indicating
entry to the Basic Features Menu. If this is the menu
you want, release the button and go on to Step 3.
If the button is not released, the program jumps to the next
menu and the horn honks twice. There are three possible
menus. Select the menu you want, then release the Valet/
Program switch.
To Next Page
Loading...
Need help?
General
