EasyManuals Logo

Directed Electronics Viper 5501 Installation Guide

Directed Electronics Viper 5501
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
© 2008 Directed Electronics. All rights reserved.
Tachometer settings
¢ Virtual tach
To program Virtual Tach:
After the install is complete, remote start the car. 1.
If the car does not start on the first attempt, let the remote start attempt 2.
again.
Once the car starts, let it run until the parking lights come on.3.
When the parking lights come on, shut off the remote start with the remote 4.
- that's it! Virtual Tach is programmed.
To reset Virtual Tach, go into the remote programming grid and choose option
#4. Virtual Tach cannot be reset with the Bitwriter.
Note:
Virtual Tach cannot be used in MTS mode.
Virtual Tach handles disengaging the starter motor during remote starting – it
does not address over-rev. If the customer wants to have the over-rev protection
capability, the tach wire must be connected. This may involve more installation
shop charges than initially quoted.
Important: If the Virtual Tach mode over cranks or doesn't
crank the vehicle long enough to start and run the car, use the
Bitwriter to add or subtract the starter output time. You can
adjust the output time in increments of 50mSec of the learned
time using the Bitwriter.

Other manuals for Directed Electronics Viper 5501

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Directed Electronics Viper 5501 and is the answer not in the manual?

Directed Electronics Viper 5501 Specifications

General IconGeneral
BrandDirected Electronics
ModelViper 5501
CategoryRemote Starter
LanguageEnglish

Related product manuals