7
© 2008 Directed Electronics. All rights reserved.
What is included
The control module s
Control center with integrated status LED and Valet Override switch s
N6711T
One five-button, 2-way Supercode Responder LC Remote Control s
(p/n 7752V)
One five-button, 1-way Supercode Remote (p/n 7652V) s
A shut-down toggle switchs
Installation points to remember
This product is designed for fuel-injected, automatic transmission, or vehicles
with manual transmissions.
Important!
The default option “Manual” is a safety precaution
that forces the installer to enable the Manual Transmission Start
(MTS) routine or program the unit to the “Automatic” option
before the remote start can be activated for the first time.
The “Automatic” option should be programmed on to work with automatic trans-
missions. When the “Manual” option is selected a specific routine is required
before exiting the vehicle to enable the MTS mode.
¢Virtual tach
Virtual Tach is a new feature for Directed this year. It is the default RPM-sensing
method for the new Responder LC hybrid keyless entry/remote start systems.
Virtual Tach gives the installer the performance of a hard wired tach, with the
convenience of voltage sensing. It is far superior to any voltage-sense feature
you’ve tried before.
Virtual Tach monitors the cranking voltage of the vehicle using a very fast micro
controller and an analog-to-digital converter. The microprocessor “saves” the
base voltage as a reference. When Virtual Tach “sees” the slightest uptick in
voltage, indicating that the alternator is charging the battery, the starter motor
shuts off instantly.
To Next Page
Loading...
Need help?
General
