EasyManuals Logo

Directed Electronics Viper 5501 Installation Guide

Directed Electronics Viper 5501
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
24
© 2008 Directed Electronics. All rights reserved.
Note: A 1-amp diode must be installed in line on the factory wire between the
wait-to-start indicator and the ECM. (See the following diagram for details).
(+)WAIT-TO-START WIRE

Table of Contents

Other manuals for Directed Electronics Viper 5501

Preview: Owner's Guide
Owner's Guide48 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Directed Electronics Viper 5501 and is the answer not in the manual?

Directed Electronics Viper 5501 Specifications

General IconGeneral
BrandDirected Electronics
ModelViper 5501
CategoryRemote Starter
LanguageEnglish

Related product manuals