39
© 2008 Directed Electronics. All rights reserved.
Step Function
1
Auto Learn Standard Configuration* (default). The auto learn con-
figuration will automatically setup the remote button configuration.
Note: Due to the Supercode protocol, you cannot change the con-
figuration.
2
Delete remotes: This feature will erase all remotes from the memory
of the security system. This is useful in cases when a customer’s
remote is lost or stolen.
Note: This will not reset the programmed features of the system or
reset the Virtual Tach setting.
3
Reset Features: This resets all the features of the system to the fac-
tory default settings.
Note: This feature does not delete the remotes from the system or
reset the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual
Tach, and on the next remote start sequence the unit will begin
virtual tach initialization.
Note: The “Zap” feature on the Bitwriter will not reset the Virtual
tach setting.
3.Transmit. Press the button on the remote control.
The vehicle's horn honks to confirm that the code has
been successfully programmed. It is not possible to teach
a remote control button to the system more than once.
4. Release. Once the code is learned, you can
advance from one function step to another by re-
leasing the Valet/Program switch and tapping
it to advance function steps and then holding it.
Learn Routine is exited if:
The ignition is turned offs
The program switch is pressed too many timess
More than 30 seconds elapses between stepss
To Next Page
Loading...
Need help?
General
