EasyManuals Logo

Directed Electronics Viper 5501 Installation Guide

Directed Electronics Viper 5501
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
63
© 2008 Directed Electronics. All rights reserved.
The vehicle will start, but will only run for 10 seconds.s
Is the remote start programmed for voltage sense? If this does not work, a 1.
tach wire should be used.
Check shutdown diagnostics.2.
The climate control system does not work while the unit is operating the s
vehicle.
Either the wrong accessory wire is being energized or more than one ignition
or accessory wire must be energized in order to operate the climate control
system.
Manual Transmission Start diagnosticss
When enabling MTS, if you get a failure notification from the remote or the
vehicle fails to remain started when you shut off the key, check for following:
Hood Open (gray wire)s
Foot Brake active (brown wire)s
No Parking Brake input-Black/white neutral safety wire not showing s
ground with parking brake set.
Tach not hooked up or programmeds
Toggle switch not installed or not in the ON position.s

Other manuals for Directed Electronics Viper 5501

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Directed Electronics Viper 5501 and is the answer not in the manual?

Directed Electronics Viper 5501 Specifications

General IconGeneral
BrandDirected Electronics
ModelViper 5501
CategoryRemote Starter
LanguageEnglish

Related product manuals