12
© 2015 Directed. All rights reserved.
the button is released the vehicle control indicator will change.
While the system is armed, if the Warn Away or full alarm is triggered
on any of the programmed vehicles, that vehicle’s number will be dis-
played and the LCD will display that vehicle’s status. To change back to
the original vehicle that was selected press the
button for one second
and release until the desired vehicle number is shown.
For example, if the remote was originally on vehicle number 1 and a
trigger page was received for vehicle number 2, the remote will show
the alarm trigger and show number 2 on the display. After clearing the
page, you can select the desired vehicle to be controlled.
Note: This feature is only applicable to the 2-way remote control.
Paging Features
The control module sends a page to the remote as confirmation of a
received command, or alarm system status.
When the remote receives a page notification, it beeps or vibrates and
the alarm status, armed/locked or disarmed/unlocked, (the lock or un-
lock icon) appears on the LCD. If the alarm has been triggered, the
remote LCD displays the zone triggered. To clear the alarm page, press
any button on the remote. The LCD information is also cleared.
Note: You will not be able to send a command, until the alarm page
is cleared.
To Next Page
Loading...