15
© 2015 Directed. All rights reserved.
Multi-level Security Arming (security only)
Multi-Level Security Arming allows you to select which of the security
system’s inputs or sensors are active, or are bypassed when the system
is armed (See the "Table of zones" on page 23 of this guide).
Press
one time to arm the system, siren chirps one time. Pressing
again activates Multi-Level Security Arming.
Each time
is pressed consecutively, a different security level is se-
lected, as described in the below table:
Press
Siren chirps Zone bypassed
2 times 2 times followed by 1 long chirp 2
3 times 3 times followed by 1 long chirp 4
4 times 4 times followed by 1 long chirp 2 & 4
5 times 5 times followed by 1 long chirp all zones except 5
Each press of the button ascends to the next security level, the re-
mote sounds one beep, and the lock icon flashes five times.
Multi-Level Security Arming applies to a single arming cycle. The next
time the system is armed, all the zones will be active again.
Arming While Driving (security only)
Your security system can be armed while driving the vehicle.
Press
on the remote control for two seconds while the vehicle is
running. The siren/horn will sound once to indicate that the security
system is armed, and then once more to indicate that the ig ni tion is on.
The system will not respond to any input except the door triggers, and
the starter kill relay (if installed) will not be activated. Once you have
To Next Page
Loading...