Directed 5305V - Remote and System Operations; Passive Arming;Locking; Warn Away Response (Security Only)

To Next Page

To Previous Page

Remote and System Operations

Passive Arming/Locking

The system can be programmed to arm/lock itself au to mat i cal ly (called

pas sive arming/locking). If the system is programmed for passive arming/

locking, it will automatically arm/lock 30 seconds after the ignition is

turned off and the system detects that you have left the vehicle by opening

and closing a door. Whenever the system is in its 30-sec ond passive arm-

ing/locking count down, the status LED will ﬂash twice as fast as it does

when the system is armed/locked. At the 20-second point of the count-

down, the siren/horn will sound to indicate that the system is about to

arm/lock. At the 30-second point, the parking lights will ﬂash to indicate

that the system is armed/locked.

Note: If any protected entry point (such as a door or a switch-protected

trunk or hood) is open, the system will not passively arm/lock (un-

less forced passive arming/locking is programmed on). See "Forced

passive arming" under "Programming Options" on page 27 of this

guide.

Warn Away

Response (security only)

A Warn Away Response consists of an alarm page along with the

responses described below.

• Shock (impact) Sensor - Light impacts to the vehicle will ﬂash the

vehicle lights and sound the siren/horn for a few seconds.

• 2-way Remote Control Notiﬁcation - Ten quick beeps (or one vi-

bration).

• The 2-way remote control will enter Page Recognition Mode and

operate alarm page alerts.