Directed 5305V - Valet Mode

17
© 2015 Directed. All rights reserved.
Important: The control center button can be programmed to re-
spond from one to five presses for the disarm/disable function.
You must check with the installer to verify the programming for
your individual unit.
Valet Mode
You can prevent your system from automatically arming/locking and
trig ger ing by using Valet Mode. This is very useful when washing the
ve hi cle or having it serviced. In Valet Mode, the system/starter kill will
not arm/enable, even with the remote control, but all convenience func-
tions (door locks, trunk re lease, etc.) will continue to work nor mal ly.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the control center button within 10 seconds.
To enter or exit Valet Mode using the remote control:
1. Open any vehicle door.
2. Press
.
3. Press
and then press again.
The status LED lights solidly if you are en ter ing Valet Mode, and goes
off when you exit Valet Mode.
Note: The 2-way remote flashes the
for three seconds when enter-
ing valet mode and flashes the
for three seconds and beeps twice
when exiting valet mode. It does not offer arm/disarm confirmations
when the system is in valet mode.