19
© 2015 Directed. All rights reserved.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn it to the On position.
2. Press the brake pedal.
3. Disengage the parking brake.
4. Place the vehicle in gear and drive to your destination.
Note: If the brake pedal is pressed or the parking brake is disengaged
before the key is in the ON position, the engine will shut down.
While the vehicle is running during remote start operation, the system
monitors the ve hi cle and automatically shuts down the engine if the
system receives any of the following:
• The brake pedal is pressed
• The hood is opened
• The shutdown toggle switch is put into the Off position
• The parking brake is disengaged
• Runtime (12, 24, or 60 minutes) expires
• The remote start activation procedure from the remote is repeated.
Pit Stop Mode
The Pit Stop mode feature allows the vehicle to remain running after the
key has been removed from the ignition. This feature is useful for oc-
casions when you wish to exit and lock the vehicle for short periods of
time, but would like to leave the motor running and the climate controls
on.
To perform Pit Stop mode:
1. Before turning off the engine, ensure that the parking brake is set.
Press and release
on the remote the amount of times the system
has been programmed to activate the remote start (or press and
release the optional momentary switch). Then wait five seconds.
To Next Page
Loading...