EasyManuals Logo

Directed XpressKit User Manual

Directed XpressKit
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Rev.: 20 708115
Platform: DBALL2
Firmware TL6:
© 201 Directed.7 All rights reserved.
13
BRX: pin 26
BTX: pin 25
Body ECU
(white 30-pin onnector)c
(-) Trunk Status Input
[1] ( ) T Status InputAC ach
(-) Door Status Input
(-) E-Brake Status Input
(-) Ground
(+) Brake Input
(-) Hood Status Input
HS CAN High: 3Tan/Black:
HS CAN Low: 4Tan:
(-) Ground: 12Brown :/Red
(-) Output:SLP 11Yellow :/Red
(+) 12V :Input 13Red:
(-) Ground: 14Black:
(+) Brake Output: Gray: 6
(-) Hood Status Output: 9Violet/Brown:
Immo Data 1: Yellow/Black: 10
(+) Ignition Status Output: Gray/Black: 7
Immo Data 2: Orange/Black: 11
(-) Push-to-Start Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
(-) Trunk Status Output: Red/Black: 4
[1] ( ) Tach Output: 5AC Violet/White:
(-) E-Brake : 1Status Black/White:
Diagnostic Connector OBDII
(connector side view)
Steering Lock
(black 7-pin onnector)c
(+) Ignition Input/Output
Remote
Starter
(-) (Status)GWR
(-) OutputLock
(+) Starter Output
(-) OutputUnlock
(-) Trunk Output
1: (-) Lock InputGreen:
2: (-) Unlock InputBlue:
3: (-) Trunk InputRed/White:
8: (+) Starter InputViolet:
10: Blue/White:
(-) (Status) InputGWR
9: (+) Ignition InputPink:
18
169
Push-toStart
(Black 10-pin onnector)c
ENGINE
START
STOP
2345
109876
1
(-) PTS:
pin 1
12
3
5
4
7
6
HS CAN High pin 6:
HS CAN Low: pin 14
(+) :12V
pin 16
(-) SLP:
pin 4
(+) 12V Input
1
7
19
3
9
21 30
6
4
28
2625
8
20
2
10 12
2223
24
11
14 15
27
181716
5
29
(+) 12V
Page 11
Installation Type 4
10
RF
Prog utton. B
LED
4
2
P#: 2D65XKD
TX
(-) Ground
RX
(+)12V
2DBALL
14
12
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the diagnostic connector.OBDII
[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
Not required in D2D mode.
Autolight Interrupt (veh.side): 9Orange/Yellow:
Autolight Interrupt (conn.side): 8Yellow:
(-) lights: pinAuto 28
Fuse 7.5A
(-) Parking Lights Output
(-) Parking lights: pin 30
Do not connect these wires:
accessory ignition starter,,
from the remote starter to the vehicle.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Directed XpressKit and is the answer not in the manual?

Directed XpressKit Specifications

General IconGeneral
BrandDirected
ModelXpressKit
CategoryRemote Starter
LanguageEnglish

Related product manuals